File list

From Bytesmiths

Jump to: navigation, search

This special page shows all uploaded files. By default the last uploaded files are shown at top of the list. A click on a column header changes the sorting.

File list
 

descDate Name User Size Description
07:25, 24 February 2011 VVGFuel.jpg (file) Jan Steinman 93 KB (Veggie Van Gogh's fuel system schematic.)
04:20, 17 November 2006 The_Making_of_Kitty_Moov_2.jpg (file) Bytesmiths 61 KB (Jig I set up for photographing small ceramics and other art objects.)
04:19, 17 November 2006 The_Making_of_Kitty_Moov.jpg (file) Bytesmiths 50 KB (Jig I set up for photographing small ceramics and other art objects.)
00:15, 10 March 2006 Moby_on_Rydman.jpg (file) Bytesmiths 33 KB (Moby, the "Gweat White Wefwigewated Twaiwer", in the court by our West Linn house, waiting to have all our earthly possessions loaded inside, en-route to Canada.)
19:24, 25 December 2005 Original_exterior_front.JPG (file) Jan Steinman 72 KB  
19:23, 25 December 2005 Original_exterior_rear.JPG (file) Jan Steinman 60 KB  
19:23, 25 December 2005 Original_interior_condition_3.JPG (file) Jan Steinman 105 KB  
19:22, 25 December 2005 Original_interior_condition_2.JPG (file) Jan Steinman 105 KB  
19:22, 25 December 2005 Original_interior_condition.JPG (file) Jan Steinman 93 KB  
19:21, 25 December 2005 Empty_aluminum_box_front.JPG (file) Jan Steinman 85 KB  
19:20, 25 December 2005 Empty_aluminum_box.JPG (file) Jan Steinman 62 KB  
19:05, 25 December 2005 Electronics_mounting.JPG (file) Jan Steinman 102 KB  
18:54, 25 December 2005 Jan_installing_Ranger.JPG (file) Jan Steinman 85 KB  
18:52, 25 December 2005 Ranger_installed_top.JPG (file) Jan Steinman 94 KB  
18:51, 25 December 2005 Transmission_gone.JPG (file) Jan Steinman 119 KB  
18:41, 25 December 2005 Ranger_installed.JPG (file) Jan Steinman 100 KB (The Ranger overdrive, installed between the stock Muncie SM465 and the bell housing.)
18:36, 25 December 2005 Floor_insulation.JPG (file) Jan Steinman 92 KB (The floor is insulated with 2" rigid foam insulation, to keep heat from the heated fuel tanks from entering the cargo space.)
18:35, 25 December 2005 Tank_bottom_detail.JPG (file) Jan Steinman 107 KB (Tank bottom detail. The two 3/4" hose barbs feed the coolant loop; the smaller 3/8" hose barb underneath is the fuel draw.)
18:33, 25 December 2005 Tank_top_detail.jpg (file) Jan Steinman 113 KB (Detail of top of vegoil tank, showing the top fill/recirculate fitting (left) and the vent (right).)
18:31, 25 December 2005 Tanks_ready_to_install.JPG (file) Jan Steinman 164 KB (The vegoil tanks, insulated and fitted, ready for installation.)
08:10, 25 December 2005 Filling.jpg (file) Jan Steinman 82 KB (Jan, filling Veggie Van Gogh from 35-pound "cubees" of used vegetable oil.)
08:08, 25 December 2005 Cleaning_Racor.jpg (file) Jan Steinman 81 KB (Jan, disassembling the Racor filter for cleaning.)
08:07, 25 December 2005 Fillerup.jpg (file) Jan Steinman 63 KB (Jan, filling with vegoil.)
08:07, 25 December 2005 Racor_access_hatch.jpg (file) Jan Steinman 27 KB (The new transmission cover I fabricated, showing hatch access to the Racor filter and Drylock filler hose connector.)
07:57, 25 December 2005 Vegoil_System_Components_Left.jpg (file) Jan Steinman 122 KB (Vegetable oil system components, left to right: left vegoil tank, Pollak 6-port motorized valve (left/right tanks), Vormax filter, Pollak valve (diesel/vegoil), Floscan flow senders, and Vegtherm electric fuel heater.)
07:52, 25 December 2005 Vegoil_System_Components_Right.jpg (file) Jan Steinman 28 KB (Vegetable oil system components on the right side, labeled, clockwise from left: Racor filter, Webasto coolant heater, Pollak 6-port motorized valve, and 1/4 horsepower vegetable oil gear pump.)
07:47, 25 December 2005 Temperature_Monitors.jpg (file) Jan Steinman 22 KB (Close up of twelve channels of temperature monitoring, six on either side. To the right is the left vegoil tank gauge. To the bottom is the top air suspension air pressure gauge.)
07:45, 25 December 2005 FlowScan_Monitor.jpg (file) Jan Steinman 10 KB (Installation of Floscan monitor in the control/monitor panel of Veggie Van Gogh.)
17:42, 24 December 2005 Tach_Sender_9.jpg (file) Jan Steinman 19 KB (Crankshaft pulley magnets next to tach sender.)
17:42, 24 December 2005 Tach_Sender_8.jpg (file) Jan Steinman 15 KB (Tach sender and crankshaft pulley with magnets, viewed from below. I set the spacing by using a bit of 0.5mm (0.020") between the two while tightening the bolt holding the tach sender bracket to the frame.)
17:39, 24 December 2005 Tach_Sender_7.jpg (file) Jan Steinman 12 KB (Tach sender mounted to block next to crankshaft pulley, with fan pulley above.)
17:38, 24 December 2005 Tach_Sender_6.jpg (file) Jan Steinman 51 KB (Tach sender mounted on block next to crankshaft pulley. I epoxied two magnets, arrange in opposite polarity, to the crankshaft pulley. These magnets cause the hall-effect sensor to produce a pulse once each revolution.)
17:36, 24 December 2005 Tach_Sender_5.jpg (file) Jan Steinman 12 KB (Tach sender on bracket. The bracket is a section of 2.5cm (1") aluminum angle. the hole to the bottom mounts on a bolt coming out of the engine block near the crankshaft pulley.)
17:34, 24 December 2005 Tach_Sender_4.jpg (file) Jan Steinman 9 KB (Tach sender epoxied and tie-wrapped to fabricated bracket.)
17:33, 24 December 2005 Tach_Sender_3.jpg (file) Jan Steinman 6 KB (Hall-effect tach sender close-up, with thumb for scale.)
17:32, 24 December 2005 Tach_Sender_2.jpg (file) Jan Steinman 9 KB (Hall-effect tach sender close-up.)
17:31, 24 December 2005 Tach_Sender_1.jpg (file) Jan Steinman 27 KB (The hall-effect tach sender being assembled. Yet to add is the heat-shrink covering of the leads.)
17:29, 24 December 2005 Relay_Rewire_5.jpg (file) Jan Steinman 32 KB (The new pressure switch (cover off for adjusting) and relay box installed.)
17:28, 24 December 2005 Relay_Rewire_4.jpg (file) Jan Steinman 33 KB (The relay box is mounted, wired, and leads are dressed -- much neater and more maintainable than before! Also shown is the pressure switch in the upper left, which I added to keep from over-filling the tanks. When the pressure gets too high, this switch t)
17:26, 24 December 2005 Relay_Rewire_3.jpg (file) Jan Steinman 20 KB (I replaced the cheap automotive relays with some lovely socketed relays and put the whole thing in a waterproof box with connectors. Now if a relay goes out, I simply unplug it and plug in a new one. These relays came out of my junk box. ''Sorry about the)
17:06, 24 December 2005 Relay_Rewire_2.jpg (file) Jan Steinman 16 KB (The old relays after removal. Note the one in front is a lump of charcoal.)
17:05, 24 December 2005 Relay_Rewire_1.jpg (file) Jan Steinman 31 KB (What a mess! I have numerous multi-wire cables running to this point, which had previously been soldered to a panel holding seven 30 amp automotive relays. This picture is after removal of the relay bank, after one of them fried.)
16:36, 24 December 2005 VVG_Demo.JPG (file) Jan Steinman 99 KB (Carol relaxed during a demonstration we gave at a gathering of ''Stop Oregon Litter and Vandalism'' (SOLV).)
16:31, 24 December 2005 VVG_Sunrise.JPG (file) Jan Steinman 66 KB (We parked for the night about 500 meters above Sheridan, Wyoming.)
20:53, 19 December 2005 PaintYourWagonSmall.mov (file) Jan Steinman 398 KB  
02:04, 19 December 2005 Wizard_Island,_future_view.jpg (file) Jan Steinman 37 KB  
01:52, 19 December 2005 Racor_&_Drylock.jpg (file) Jan Steinman 27 KB  
01:52, 19 December 2005 Tubing1.jpg (file) Jan Steinman 28 KB  
01:36, 19 December 2005 Filler_Hose_Storage.jpg (file) Jan Steinman 20 KB  
01:35, 19 December 2005 Filler_Hose_Docked.jpg (file) Jan Steinman 40 KB  

First page
First page
Previous page
Previous page
Last page
Last page
Views
Personal tools
Get our newsletter!
Name:
Email Address: